PREPARATION OF SOME NEW SURFACTANTS AND INVESTIGATION OF THEIR SURFACE AND THERMODYNAMIC PROPERTIES TO USE IN ENHANCED OIL RECOVERY
Paper ID : 1068-ICBAS2024
Authors
Esraa Hamada Kalboush *1, Baheya M. Elsadek2, Entsar E. Badr3, Ahmed I. Khodair4, A. M. Al sabagh5
1Chemistry department , Faculty of science , Al-azhar university , Nasr city , cairo 11754 Egypt
21Chemisty Depart. , Faculty of Sci. , Al- Azhar Uni. ( for Girls) , Nasr city, Cairo 11754.Egypt
3Chemisty Depart. , Faculty of Sci. , Al- Azhar Uni. ( for Girls) , Nasr city, Cairo 11754.Egypt
4Chemisty Depart., Faculty of Sci., Kafrelsheikh Uni., Kafrelsheikh 33516, Egypt
5Application Depart., Egyptian Petroleum Research Institute (EPRI), Nasr City, Cairo, Egypt
Abstract
In this work, seven surface-active agents were prepared based on ricinoleic hydrazide. The six surfactants that have a nonionic moiety were prepared by a reaction of ricinoleic hydrazide with succinic anhydride in an open-ring reaction, and then the product reacted with different molecular weights of polyethylene glycol to produce this formula (PMRH x). The letter seven surfactant has a cationic moiety, and its general formula is (RHATAS). Their chemical structure was confirmed by FT-IR, 1HNMR, and 13CNMR. The surface active and thermodynamic properties of these surfactants were calculated based on surface tension measurements at 25°C, 35°C, and 55°C. The interfacial tension for this surfactant was measured at the CMC concentration in formation water at 50°C and 70°C. The values of interfacial tension were cited between 10-1 and 10-2 mN/m. From the obtained data, the negative value of ΔGads and the data on interfacial tension were drawn into a visualization image to employ these surfactants in an application for increased oil recovery
Keywords
ricinoleic hydrazide derevaties, alkylated ricinoleic hydrazide, thermodynamic parameters, surface active properties, interfacial tension, biobased surfactants
Status: Accepted (Poster Presentation)